Mounted on the horizontal bar, next to the left hand horizontal pile guide is a small casting with two thumb screws and 5/16″ round rod that extends out over the tail of the pile and to which one of two fingers can be attached. Use only as many as are required to keep the sheet fairly flat. There are additional shoes and fly rods to mount over the pile to prevent the sheets from bellying out of control. These prevent sheets from being blown to the rear from the top of the pile. Two small bronze castings are porvided that mount on these guides at the tail of the sheet. As these are intended to trap the air in the sheets they should be set sufficiently close, but not to bind the sheets. The horizontal (angle type) pile guides that parallel the two top sides of the stock pile should be set in close to either side of the pile. The stock pile, properly fanned and jogged is now placed on the feeder board and raised until the top of the pile is level with the vertical front pile guides. The remainder of the vertical front pile guides then spaced across the width of the sheet. Set the left hand vertical (angle type) pile guide 1/4″ to 1/2″ closer to the center of the feeder than is the side guide on the register. By watching the opertation, one can tell quickly what amount of rise to use. When running very light paper, possibly 1 tooth of rise will be sufficient. If heavy stock such as cover stock is being run and the pile does not seem to come up fast enough then set feeder for 3 teeth to rise. The reason the feeder is set at the factory for two teeth is because this has proven to work out for normal run of stocks. Hole “B” is 1-3/16″ from center of crank gear. Hole “A” is 7/8″ from center of crank gear. When inserting wire for 1 tooth do not make any other changes. If only 1/32″ rise is wanted you just insert the wire mounted on the pawl lever in between the ratchet pawl and the ratchet. (This is for moving the ratchet 3 teeth) then adjust the same as for two teeth. To have the pile rise 3/32″ install the pawl lever crank in hold “B”. When the latch pin is in the proper position, lock firmly. To raise or lower the latch pin, adjust the lift stem adjusting nut. Adjust the latch pin by loosening the latch pin adjusting screw and this allow the latch pin to be moved in or out of the latch pin block. Then adjust the latch pin until you have it 1/32″ above the pawl lever latch and 1/32″ away from the pawl lever latch as shown. (This is for moving the ratchet two teeth) and centered over the crank gear as shown in sketch. The pawl lever crank is set in the hole “A”. The sketch below shows how to time the feeder. When raising the pile 1/16″ the ratchet pawl moves the ratchet two teeth. When the feeder leaves the factory it is set to raise the pile 1/16″ per engagement. A Guide to Buying a Paper Folding Machine.BAUM 20 ICF-3 Independent Continuous Feeder.BAUM 20 VFM 8-Pg Versatile Finishing Module. BAUM 20 VFM Versatile Finishing Modules.BAUM 20 IPF Independent Deep Pile Feeder.BAUM 714XLT Ultrafold Tabletop Folder 2nd Station.BAUM 714XA Autofold Tabletop Folder 1st Station.Our team of trained manufacturers get your product assembled and out the door-the way you ordered and when you want it.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |